Certified Attic Mold Removal
for Franklin Park Attics — Cause Before Treatment

Cold-climate zones: winter condensation from interior air infiltrating attic floor gaps. Hot-humid zones: summer outdoor air moisture infiltrating attic via inadequate ventilation. Both scenarios worsened by exhaust fan termination inside attic. Cause determines correction.

Sapstain from lumber mill organisms (typically Ophiostoma species) appears as uniform blue-black or grey-black staining flat on the wood surface — it's actually in the wood fiber from the milling and drying process, present before the panel was installed. It doesn't have visible surface texture, white or grey hyphal fringe, or fuzzy growth patterns. Active mold colonies have surface texture, may have white or grey sporulating fringe, and are associated with elevated MC% in the panel. We confirm by measuring MC% at sapstained panels — consistently low MC% (below 14%) in a dry attic confirms non-active status; elevated MC% indicates active growth associated with current moisture conditions. Lab surface sampling can confirm when visual and moisture data don't give a clear answer.

Most attic sheathing with surface mold colonization — panels with MC% within the treatable range (elevated but below the threshold where structural decay is occurring), without physical delamination or loss of rigidity — can be treated in place with HEPA removal of loose spore material and penetrating borate application. This is the appropriate protocol for surface colonization on structurally sound panels. Replacement is required for panels with physical structural delamination (OSB losing layer cohesion) or through-penetration of decay fungi (the structural panel is softening or punky). We assess each panel individually — replacement is specified by panel location, not assumed for all darkened panels.

Inside-attic fan termination dumps bathroom moisture directly onto framing and sheathing on every use cycle. Proper rerouting requires insulated flex duct (prevents in-duct condensation), sealed connection at fan housing, and correctly sized exterior cap. Uninsulated duct, inadequate sealing, or undersized cap all partially defeat the purpose.

We apply treatment products only to structural wood components — sheathing and rafters — not to roofing materials. SDS sheets for all products we apply are available on request and can be provided to your roofing manufacturer representative for review. For panels requiring structural replacement that are under shingles, coordination with a roofing contractor is required — the roofing material is removed by the roofer, sheathing is replaced by our crew, and the roofing contractor reinstalls. We coordinate scheduling for panels requiring this approach.